8699795
Double Burner Angle Iron Stove
V4.0
4
For technical questions call 1-800-665-8685
2. Do not connect to a remote gas supply. The stove is designed for use with
butane cylinders only.
3. The pot/pan must fit on the struts of the drip pan (B).
a. Do not straddle both heating elements with a single pot/pan or allow
an oversized pot/pan to sit on the side panel (I). The pot/pan may
become unbalanced and slip off the stove.
4. Keep area around the stove clear of debris or materials that can ignite or
may be damaged by heat.
5. Do not touch the stove’s components until sufficient time has passed to
allow it to cool. Touching it before it is cool could cause a burn injury.
6. Remove the butane cartridge before performing maintenance on the stove.
BUTANE GAS SAFETY PRECAUTIONS
WARNING! If at any time gas odour is detected, immediately discontinue
operation until the source of gas has been located and corrected.
1. Use only butane gas. Follow all safety instructions on the butane cylinder.
2. For outdoor use only. The area must be well ventilated. Provide a minimum
opening of 1 sq. ft. (0.093m
2
) near the floor and 1 sq. ft. (0.093m
2
) near
the ceiling. Do not use inside of a house, camper, tent, vehicle or any other
type of unvented enclosed area.
3. Do not use the heater in a basement or below ground level. Butane is
heavier than air and can collect in a low area.
4. Before connecting the heater to the butane cylinder, make sure the stove
regulator knob is in the OFF position. Always connect and light the stove in
areas free of open flames.
5. Do not move, handle or service while hot or burning. Do not detach the
butane cylinder from the hot or burning stove.
6. Use only in accordance with local codes.
7. The LP-gas cylinder(s) used with a stove shall be constructed and marked
in accordance with the specifications for LP-gas cylinders of the U.S.
Department of Transportation or Transport Canada, the Standard for
Cylinders, Spheres and Tubes for the Transportation of Dangerous Goods,
CAN/CSA B339.
