V1.0
High-Lift Hydraulic Transmission Jack
8667883
Visit www.princessauto.com for more information
9
CARE & MAINTENANCE
1.
Maintain the tool with care. A tool in good condition is efficient, easier to
control and will have fewer problems.
2. Inspect the tool components periodically. Repair or replace damaged or
worn components. Only use identical replacement parts when servicing.
3.
Follow instructions for lubricating and changing accessories.
4.
Only use accessories intended for use with this tool.
5.
Keep the tool handles clean, dry and free from oil/grease at all times.
6.
Maintain the tool’s labels and name plates. These carry important information.
If unreadable or missing, contact Princess Auto Ltd. for replacements.
WARNING! Only qualified service personnel should repair the tool. An
improperly repaired tool may present a hazard to the user and/or others.
HYDRAULIC RAM MAINTENANCE
Monthly maintenance is recommended for the hydraulic ram. Any restrictions due
to dirt, rust, etc. can cause the either slow movement or extremely rapid jerks,
damaging the internal components. The following steps are designed to keep the
pump maintained and operational.
1.
Lubricate the cylinder and the pumping mechanism with light oil.
2.
Visually inspect for cracked welds, bent, loose, missing parts or hydraulic
oil leaks.
3.
Inspect the hydraulic ram immediately if it was subjected to an abnormal load
or shock load.
4.
Remove any hydraulic pump from service that is damaged, worn down or
operates abnormally, until repaired by an authorized service technician.
5.
Check and maintain the ram oil level.
6.
Always store your tool with the hydraulic ram in the fully retracted position.
This will help protect critical areas from corrosion.
7.
Do not use brake or transmission fluids or regular motor oil as they can
damage the seals. Always purchase and use products labeled Hydraulic Oil.
BLEEDING THE HYDRAULIC SYSTEM
Bleed excess air from the hydraulic system as follows:
1.
Open the release valve by turning it counterclockwise.
2.
Remove the oil filler screw and fill the pump with hydraulic fluid.
3.
Wait 5 minutes for trapped air to rise to the surface.
