Visit www.princessauto.com for more information
5
8535023
V 4.0
5 in. Angle Grinder
6. Maintain tools with care. Keep the cutting tools sharp and clean. Properly maintained
tools with sharp cutting edges are less likely to bind and are easier to control.
7. Check for misalignment or binding of moving parts, breakage of parts and any other
condition that may affect the tools operation. If damaged, have the tool serviced
before using. Many accidents are caused by poorly maintained tools.
8. Some accessories suitable for one tool may become hazardous when used on another
tool. Please check all accessories to be used are suitable.
SERVICE
1. Tool service must be performed only by qualified repair personnel. Service or
maintenance performed by unqualified personnel could result in a risk of injury.
2. When servicing a tool, use only identical replacement parts.
SPECIFIC SAFETY RULES FOR ANGLE GRINDERS
1. Always use proper guard with grinding wheel. A guard protects operator from broken
wheel fragments.
2. Accessories must be rated for at least the speed recommended on the tool warning label.
Wheels and other accessories running over rated speed can fly apart and cause injury.
3. Hold tool by insulated gripping surfaces when performing an operation where the
cutting tool may contact hidden wiring or its own cord.
4. Make sure the grinding wheel is not contacting the work piece before the switch is
turned on.
5. Grinding wheel and guard must be securely attached as described in this operating
manual before connecting the angle grinder to power source.
6. Grinding wheel must be stored in a dry place.
7. Always hold the grinder firmly with two hands while working and at all times when it
is running.
8. Use only quality certified grinding wheels.
9. Keep hands away from rotating parts.
10. Be careful not to damage the spindle, outer flange and inner flange. Damage to these
parts could result in wheel breakage.
When starting the tool (install with a new or replacement wheel), hold the tool in a well
protected area and let it run for one minute to check if the wheel is good or not. Never starting
the tool while the operator is standing at in line with the wheel.
