1/2 HP Stainless Steel Sewage Pump
Visit www.princessauto.com for more information
3
8519209
V 3.04
NOTE:
Keep this manual for the safety warnings, precautions and operating, inspection and
maintenance instructions.
Work Area
1. Operate in a safe work environment. Keep your work area clean and well lit.
2. Do not install in the presence of flammable gases or liquids.
3. Keep anyone not wearing the appropriate safety equipment away from the work area.
4. Always lock up tools and keep them out of the reach of children.
NOTE:
Minimize distractions in the work environment. Distractions can cause you to lose control of
the tool.
Personal Safety
CAUTION! Wear protective equipment approved by the Canadian Standards Association (CSA) or
American National Standards Institute (ANSI) when using the tool.
1. Dress properly, wear protective equipment. Use breathing, ear, eye, face, foot, hand and
head protection. Always wear ANSI approved impact safety goggles, which must provide
both frontal and side protection. Protect your hands with suitable gloves. Protect your head
from falling objects by wearing a hard hat. Wear an ANSI approved dust mask or respirator
when working around chemical dusts and mists. Wear ANSI approved earplugs. Protective,
electrically non-conductive clothes and non-skid footwear are recommended when working.
Wear steel-toed boots to prevent injury from falling objects.
2. Control the tool, personal movement and the work environment to avoid personal injury or
damage to the tool. Stay alert, watch what you are doing and use your common sense.
3. Keep articles of clothing, jewelry, hair, etc., away from moving parts to avoid entanglement
with a tool.
4. Do not operate any machine / tool when tired or under the influence of drugs, alcohol
or medications.
5. Do not overreach when operating a tool. Proper footing and balance enables better control in
unexpected situations.
SPECIFIC SAFETY PRECAUTION
WARNING! The pump motor is equipped with an automatic resetting thermal protector and may
restart unexpectedly.
1. Wear safety glasses when working with pumps.
2. Do not run the pump if there is no water in the system.
3. Do not power this device with anything other than a 115 volt power source.
4. Connect this product to a grounded circuit equipped with a Ground Fault Circuit Interrupter
(GFCI) device.
5. Vent sewage or septic tank according to local codes.
6. Do not install the pump in any location classified as hazardous by the National Electrical
Code, ANSI / NFPA 80-1984 or the Canadian Electrical Code.
7. Be sure that construction and access to septic sumps conform with all OSHA requirements.
8. Risk of fire or explosion. Do not pump flammable or explosive fluids such as gasoline, fuel
oil, kerosene, etc.
9. Do not use in a flammable and / or explosive environment.
Summary of Contents for 8519209
Page 10: ......
