5.
Add more thinner if the mixture is too thick or paint if the mixture is too
thin. Repeat steps 3 and 4 until you are satisfied with the thickness.
6.
Stir the thinned-paint each time before refilling the paint cup. Remove
lumps or a 'surface skin' by straining the paint mixture through
cheesecloth, nylon stocking material or a commercial paint strainer with a
60-mesh.
CARE & MAINTENANCE
1.
Maintain the tool with care. A tool in good condition is efficient, easier to
control and will have fewer problems.
2.
Inspect the tool components periodically. Repair or replace damaged or
worn components.. Only use identical replacement parts when servicing.
3.
Only use accessories intended for use with this tool. Follow instructions
for changing accessories.
4.
Keep the tool handles or gripping surfaces clean and dry.
5.
Maintain the tool’s labels and name plates. These carry important
information. If unreadable or missing, contact Princess Auto Ltd. for
replacements.
WARNING! Only qualified service personnel should repair the tool. An
improperly repaired tool may present a hazard to the user and/or others.
CLEAN THE SPRAY GUN
1.
Turn off the air source.
2.
Disconnect the paint cup from the spray gun and empty out the remaining
contents.
3.
Add a small amount of the appropriate solvent. Check paint
manufacturer’s recommendations.
4.
Reattach the paint cup.
5.
Turn on the air source to the lowest volume.
8492910
HVLP ELECTRIC PAINT SPRAY SYSTEM
V1.0
www.princessauto.com / 1-800-665-8685
Page 12