220 lb. Mobile Tire Stand
4
For technical questions call: 1-800-665-8685
8467342
V 3.01
ASSEMBLY
1. Connect the U square tube (1), the square level (2) and the plastic base (3) with the M8x40mm
bolt (9), the M8 washer (10) and the M8 nut (11) to assembly the base.
2. Attach the bent tube (4) onto the base with the M8x40mm bolt (9), the M8 washer (10).
3. Attach the U round tube (5) to the bent tube (4) and secure with the M6x35mm round bolt (12),
the M6 washer (13) and the M6 nut (14).
4. Insert the aluminum tube (6) into the plastic base (3) and then insert the aluminum tube top (7)
into the aluminum tube (6).
5. Insert the round bolt (15) through the aluminum tube (6) to fix the plastic plate (8) in position.
Repeat for the other three round bolts (15) and plastic plates (8).
NOTE: Make sure that the round bolts (15) and the plastic plates (8) are properly assembled.
MAINTENANCE
CAUTION! Remove any load from the tire stand before performing any inspection, maintenance, or
cleaning procedures.
WARNING! To prevent serious injury from tire stand failure, do not use damaged equipment. If any
problems are noticed, have the problem corrected before further use.
1. Before each use, inspect the general condition of the tire stand. Check for loose or damaged
parts, and any other condition that may affect its safe operation.
2. Clean off any dirt, debris, oil, grease, etc. from the tire stand before loading.
3. After use, wipe external surfaces of the tire stand with a clean, moist cloth.
NOTE: Do not use solvents to clean the unit.
4. Check all hardware for tightness.
DISPOSING OF THE TOOL
If your tire stand has become damaged beyond repair, do not throw it out. Bring it to the appropriate
recycling facility.
