Rotary Pump
8
For technical questions call: 1-800-665-8685
8167595
V 3.0
NOTE:
If the pump has been left idle for an extended
period of time, it may loose its prime and need to be
re-primed, repeat step 7.
8. Once you have completed pumping the
media, it is good practice to invert the
discharge spout (F) sideways for a
non-drip operation.
RECOMMENDED USES
Oil based media, motor oils and lubricating oils.
NOTE:
Use of this equipment to pump other than
approved fluids will void the manufacturing warranty.
WARNING! Never operate the pump near a fire or
a source of sparks. Some media may be explosive
and dangerous to pump.
DISPOSING OF THE TOOL
If your tool has become damaged beyond repair, do not throw it out. Take it to the appropriate
recycling facility.
Dispose of waste liquids in accordance with local authority regulations.
TROUBLE SHOOTING
Problem
Cause
Remedy
Pump does not
dispense fluid
Pump not able to create
adequate suction
Prime pump. Follow step 7 in the
Installation & Operation section
Pump is drawing in air, instead of fluid
Tighten all connections of the
suction tube and of the suction tube
at the pump inlet
Suction tube inlet is blocked
Remove the suction tube and clean
the strainer at the tube inlet
Leakage of media
from the crankshaft
Damaged seal due to use with a media
which is not suitable for use with
this pump
Replace the seal with a
genuine replacement seal from
the manufacturer
