Check for misalignment or binding of moving parts, breakage of parts, and
any other condition that may affect the tools operation. If damaged, have the
tool serviced before using.
Many accidents are caused by poorly maintained
tools.
Use only accessories that are recommended by the manufacturer for your
model.
Accessories that may be suitable for one tool, may become hazardous
when used on another tool.
Service
Tool service must be performed only by qualified repair personnel.
Service or maintenance performed by unqualified personnel could result in a
risk of injury.
When servicing a tool, use only identical replacement parts. Follow
instructions in the Maintenance section of this manual.
Use of unauthorized
parts or failure to follow Maintenance Instructions may create a risk of
electric shock or injury.
Specific Safety Rules:
Hold tool by insulated gripping surfaces when performing an operation
where the cutting tools may contact hidden wiring or its own cord.
Contact with a “live” wire will make exposed metal parts of the tool “live” and
shock the operator.
Functional Description
I.
Impact drilling switch
2.
Forward/Reverse lever
3.
Power switch
4.
Lock on button
5.
Cable
6.
Auxiliary handle
7.
Keyless chuck
8.
Depth guide
Operation Instructions
Installing and changing drill bits.
Clear slivers and any foreign objects away from the bit and the chuck so that the
bit can be tightened securely.
Insert the bit as far as it will go into the chuck.
Switch operation
The drill is equipped with a lock-on button,
convenient for continuous drilling. Press down the
trigger switch to start drill operation, and release it
to stop. For continuous operation, press down the
trigger switch, then push in the lock-on button
before releasing the trigger switch. The drill will
continue running after release of the lock-on
button. To cease operation, press and release the
trigger switch.
WARNING!
Let the drill operate for one minute without load before beginning to
drill.
Speed Adjustment
The drill speed can be adjusted using the speed
control adjuster on the switch. Turn the speed control
adjuster clockwise to increase the speed, and
counter clockwise to decrease the speed.
Reversing Direction
The rotating direction of the drill is controlled by a
lever located above the trigger. Toggle the lever to
the right of the trigger (from rear) for a forward
drilling operation. Toggle the lever to the left of the
trigger (from rear) for a reverse drilling operation.
Hammer / Drill Switch
To alternate between drilling and hammering functions, there is a switch at the top
of the tool. Selecting the hammer icon allows the drill to function in the hammering
function, and the drill icon for the drilling function. When drilling masonry, it is
recommended to use the hammering function. The adjustable depth stop gauge
allows you to accurately drill to a pre-set depth.
Maintenance
1. The brushes should be checked periodically, and replaced when they become
worn. Replacement should only be performed by a qualified technician.
2. Keep the vent passages clear from dirt by wiping the drill periodically.
3. If anything unusual happens during operation, turn off the drill and unplug it
immediately. Inspect and repair the tool before further use. Repairs should only
be performed by a qualified technician.
Technical Specifications
Model:
8039067
Voltage:
110V~50Hz
Input Current:
6.2 amp
No load speed:
0-2,800 RPM
Chuck capacity:
1/2"
Switch on:
press 3. Lock
switch 3 in
position with
button 4.
Switch off:
press switch 3
and release
Clockwise Counter clockwise
Locking
button
Locking
button