Safety ruleS for DiamonD Wheel SaW
This diamond wheel saw is designed for cutting small and medium size tile. It is equipped with a diamond cutting
blade for excellent cutting results. This steel work top tilts up to 45° for cutting angles.
CheCK The fOllOwInG POInTs:
1. The motor and the supply voltage (120 VaC, 60 hz) match.
Use only grounded 3-wire receptacles. Do
not attempt to modify the grounding feature. Ensure the power cord and the plug are in good condition.
2. avoid using overly long extension cords.
3. always place the cutting machine on a flat surface to prevent instability.
4. never use a cracked diamond saw blade. always change worn blades before use.
5. make sure the switch is in the “Off” position (the number “0” is shown) before connecting the
machine to the power supply.
6. always keep the cord from contacting moving parts of the machine.
7. Do not apply side pressure to the saw blade. It can break.
8. Do not saw tiles that are too small to lead through.
9. Put the saw blade protector over the saw blade after use.
10. Disconnect from power supply before opening the machine.
maintenance
Caution! While maintaining and cleaning the machine, disconnect the power supply cord from the receptacle.
Never use water or other corrosive liquids to clean electrical parts of the machine. Periodic maintenance of cutting
machine will prevent unnecessary problems. Keep the ventilation slots of the cutting machine clean to prevent
overheating of the motor.
trouBleShooting
Problem
Possible Causes
likely solutions
The motor becomes hot.
The cooling ventilation slots in the motor
are blocked.
Clean the cooling ventilation slots.
The tool does not work.
The power supply source is interrupted.
Check power supply cord connection.
Check circuit breaker for power line.
Check on-off switch.
Follow all safety precautions whenever diagnosing or servicing this tool. Disconnect from power supply before servicing.
immediately sWitch off the saW in any of the folloWing cases:
1. malfunction of the plug, receptacle or damage to power supply cord.
2. Broken switch.
3. smoke or odor caused by scorched insulation.
Before oPerating the saW
1. Choose the correct saw blade for the material to be cut.
Use only a diamond saw blade with a
minimum diameter of 6" and a maximum diameter of 7". The arbor hole must be 7/8".
2. fill the water reservoir.
Important! Be sure that the water reservoir is filled completely so that the saw
blade turns through enough water. This is necessary to cool the saw blade correctly.
for any technical questions, please call 1-800-665-8685
4
