3
UNPACKING INSTRUCTION
CAUTION!
Immediately upon receiving the product, carefully unpack the carton, check the contents to ensure that all parts are
present, and have been received in good condition. Notify the shipper immediately and retain packing material for inspection if
any parts appear damage from shipping or the package itself shows signs of mishandling. Save the package and all packing
materials. In the event that the product must be returned to the factory, it is important that the product be returned in the original
factory box and packing.
If the device has been exposed to drastic temperature fluctuation (e.g. after transportation), do not switch it on immediately. The
arising condensation water might damage your device. Leave the device switched off until it has reached room temperature.
POWERSUPPLY
On the label on the backside of the product is indicated on this type of power supply must be connected. Check that the mains
voltage corresponds to this, all other voltages than specified, the light effect can be irreparably damaged. The product must also
be directly connected to the mains and may be used. No dimmer or adjustable power supply.
Always connect the device to a protected circuit (circuit breaker or fuse). Make sure the device has an appropriate
electrical ground to avoid the risk of electrocution or fire.
CONTROLS AND CONNECTIONS
1. USB PORT:
You can play sound files from a USB device by
connecting the device to this slot.
2. BT STREAMING AUDIO BUTTON:
See chapter “CONNECTING
WITH BT FOR AUDIO STREAMING
” for detailed instructions on how
to set up a BT connection.
3. COMBO JACK INPUT:
Combo jack input, suitable for both XLR and
6.3mm jack.
4. MIX OUTPUT:
XLR mix output for channel A and B.
5. DSP CONTROL:
Knob to control the digital sound processor.
Mode:
Music / Live / Speech / DJ
Location:
Normal / Monitor
EQ:
High / Mid / Low
Sub:
Off / 80Hz / 100Hz / 120Hz / 150Hz
Delay:
Off / 0.1~16ms per 0.1ms
LCD Dim:
On / Off
Brightness Level
Contrast Level
6. OUTPUT LEVEL CONTROLS:
Adjust the volume of both A and B
channels.
7. MIC
– LINE SWITCH:
Switch between microphone and line channel.
8. AC IN AND FUSE HOLDER:
Socket for plugging in the supplied
power cord.
9. POWER SWITCH:
Switch to turn the device ON or OFF.
REPLACING THE FUSE
If the fuse is defective, replace the fuse with a fuse of the same type and
value. Before replacing the fuse, unplug mains lead.
Procedure:
Step 1: Open the fuse holder on the rear panel
with a fitting screwdriver.
Step 2: Remove the old fuse from the fuse
holder.
Step 3: Install the new fuse in the fuse holder.
Step 4: Replace the fuse holder in the
housing.
CONNECTING WITH BT FOR AUDIO STREAMING
1. Activate the BT audio streaming function on your mobile device (smartphone, tablet etc.)
from which you want to stream the music. Before attempting, please check the operating
instructions corresponding with that device.
2. Press t
he “BT” button to activate the streaming audio function.
3.
Select “
PDY SPEAKER
” on your mobile device to initiate the connection.
If password is required, you can enter "0000".
Attention:
The streaming distance is approx. 10 meter without any barrier.
Summary of Contents for 178.642
Page 14: ...14 ...
