Safety instructions
(h) Use clamps or vice to hold work. It is safer then using your hands and
frees both hands to operate the tool.
5) Servicing
(a) Have your machine repaired by qualified expert staff using original spare
parts only.
(b) Caution! The use of accessories or add-on devices other than those
recommended in these instructions may mean a risk of injury. Use original
spare parts only.
Additional Safety Instructions
1. Only use the accumulator block with the battery charger provided – using
other chargers could be dangerous.
2. Keep the accumulator block, tool and battery charger away from damp
and wet conditions.
3. Before using the battery charger, check all wires are properly connected.
4. If any wires on the charger are damaged, do not use it until these have
been replaced.
5. When the charger is not in use it should not be plugged in. When
unplugging, do not pull the plug out by the cable.
6. If the charger breaks down or suffers from other technical problems, take
it to a recognised dealership to be checked before using it again. Any
damaged parts must be replaced.
7. Take care when handling the accumulator block, do not drop it or knock
it against other things.
8. Never attempt to repair the battery charger or accumulator block yourself
as this can be extremely dan gerous. Repairs should always be carried out
by a recognised dealership.
9. Always unplug the charger before cleaning or carrying out any other
maintenance on it.
10. Do not attempt to charge the accumulator block in temperatures of
below 5 °C or above 40 °C.
11. Never throw the accumulator block into water or a fire – it may explode.
12. Turn the screwdriver immediately off after the screw is fasten ed.
Overloading and damaging the battery or motor can be prevented this
way. Use the torque to loosen the fastened screw.
UK Helpline 0905-1460005 • Ireland Helpline 1520-932626
Web Support: www.heltec.eu
Model Number: PSC-360/2LK
10
CDM6100 Ma-GB-IRE # 0808-15.indd 10
15-08-2008 09:51:11
