![background image](http://html.mh-extra.com/html/power-craft/pgsg-135/pgsg-135_user-manual-and-warranty_1586397006.webp)
Helpline No. UK / Northern Ireland 0870 7323023 • Rep. Ireland 1800 481005
Web support: www.omegawolf.com/powercraft
Model Number: PGSG-135
07
Operation
Gas filling and refilling
• Ensure the switch (1) is turned to the OFF position before filling
• Insert the gas container’s nozzle vertically into the filling valve (5)
• When the gas starts to escape from the filling valve, remove the nozzle from the
filling valve
Ignition
• Move the flow control knob (6) to the middle position
• Move the switch (1) upward and to the right
• Press down the ignition button (7) to light up the open flame
• When the unit is working as a soldering tool, 3 seconds after lighting the torch,
please move the shut off lever (2) to the left and release it. Then the open flame
will be shut off and you will find the soldering head (4) becomes red.
Shutting off
Move the switch (1) upwards and to the left. The switch will return to OFF position.
Flame length or temperature adjustment
After ignition, turn the flow control knob (6) to the right to increase the flame length
of the torch or the temperature of soldering tip or hot air. After ignition, turn the
flow control knob to the left to decrease the flame length or the temperature.
Operating tips
• Soldering tips must be tin-plated before using them for the first time. A thin layer
of solder should be applied to the tip when it has been heated.
• Soldering should NOT be carried out on “live” circuits, as this soldering unit does
not possess any special electrical insulation
• Keep your soldering sponge moist
How to fit for replace different accessoires
Always allow unit to cool before removing or replacing tips
Replace soldering tips
• With 7 mm wrench (15) on the soldering tip or hot blow head (9 till 14) and 8 mm
wrench on the soldering head (4), you can tight the tip or hot blow head or
unscrew them.
• When you unscrew the nut (3), you can remove the guard (8) and soldering head
Helpline No. UK / Northern Ireland 0870 7323023 • Rep. Ireland 1800 481005
Web support: www.omegawolf.com/powercraft
Model Number: PGSG-135
06
Safety instructions
The following symbols are used in these instructions:
Read the instructions carefully.
Conformity with the relevant EU safety directives.
Danger of life and risk of injury as well as risk of damage to the
machine in case of non-adherence to the safety instructions in
these instructions of use.
Danger of electric shock.
Warning! High temperature.
Additional safety instructions
• Do not fill gas or store near open flame, heater or combustible materials
• Use only high quality butane gas
• Butane gas is highly flammable, please handle with care
• Do not drop, puncture, or incinerate
• Do not store or operate in a place where the temperature is above 50º C
(122º F)
• Keep out of reach of children
• Cool down before putting protective cap on and before storing
• Always ignite your micro soldering torch with the pizzo-electric igniter,
never use a lighter or match.
• Allow any spillage to evaporate
• Do not fill in a confined area
• Ensure that the area you are filling in is well ventilated.
• Max. working time: approx. 1 hour
• After filling or refilling with gas, wait for approximately 2 minutes so that
the gas in the cylinder becomes stable.