![background image](http://html.mh-extra.com/html/power-craft/89033/89033_instruction-manual_1586394036.webp)
36
Adjusting clutch cables
Turn the adjustment handle until the cable is
tightened or loosened as required.
Testing the clutch
Two people are needed for this test.
Tip the machine carefully over until the bottom is
exposed. Make sure the machine does not fall over
and that petrol and oil do not leak.
Slacken the screws on the chassis plate, to give
access to the clutch.
Release drive clutch handle. Put the gear stick in
every position whilst checking that the clutch
plate does not come in contact with the flywheel
at any point. If it does, slacken the drive clutch
cable.
Press the drive clutch handle and check that the
clutch plate and flywheel engage for each gear.
If they do not, tighten the drive clutch cable.
Clean the clutch plate and flywheel if they are
iced-up or dirty.
Storage
When the machine is to be stored for long periods
(see Cleaning and Maintenance for further
instructions):
·
Drain and clean the fuel tank
·
Drain engine oil
·
Wipe off engine exterior with a soft cloth
·
Clean the machine and cover all metal surfaces
with a film of light oil.
Store in clean, dry, well-ventilated place.
Cleaning and maintenance
Before use:
Check air filter and clean if necessary.
Check all bolts, nuts and fittings for tightness.
Check oil and petrol levels, top up if required.
Check tyre pressure is approx. 1 bar.
After use:
Clean the machine with warm water to remove
snow and dirt on the blade, impeller and discharge
pipe.
Apply a light oil or WD40 to all moving parts.
Engine cleaning and maintenance
After 25 hours operation:
Clean engine air filter.
After 50 hours operation:
Clean oil filter.
Remove spark plug and remove any deposits.
Adjust electrode gap to 0.6-0.7 mm.
ENGLISH
INSTRUCTION MANUAL
Summary of Contents for 89033
Page 45: ...45 ILLUSTRATION ...