17
ENGLISH
INSTRUCTION MANUAL
Replacing the brush edge
If the brush edge is damaged or broken, it must
be replaced.
Remove the sanding disc.
Remove the six screws holding the brush edge in
place.
Remove the brush edge.
Position the new brush edge and screw it
securely in place using the six screws.
Replace the sanding disc.
Cleaning and maintenance
Clean the wall and ceiling sander with a brush
after use, or blow it clean with pressurised air.
Environmental information
HP Værktøj A/S endeavours to manufacture
environmentally friendly electrical and electronic
products; we also wish to contribute to the safe
disposal of waste substances which may be
environmentally hazardous.
A healthy environment is important for everyone,
and we have therefore set ourselves the target of
complying with the requirements in the EU's
initiatives in this area, which means we guarantee
the environmentally sound collection, treatment,
recovery and disposal of electronic equipment
which might otherwise harm the environment.
This also means that our products do not contain
any of the following chemicals and substances:
-
Lead
-
Mercury
-
Cadmium
-
Hexavalent chrome
-
PBB (polybrominated biphenyls) (flame
retardants)
-
PBB (polybrominated diphenyl ethers) (flame
retardants)
HP Værktøj A/S is proud to support the EU's
environmental initiatives in order to play a part in
a cleaner environment and hereby declares that
our products comply with both the WEEE
Directive (2002/96/EC) and the RoHS Directive
(2002/95/EC).
As a consumer, you can also play a part in
protecting the environment by following the
applicable environmental regulations and taking
old electrical and electronic equipment to your
local recycling center. If the equipment contains
batteries, you must remember to remove these
before you dispose of the equipment.