13
Adjusting the Control Cable
Checking the Control Cable
Release the control bar to remove the slack in the control
cable (Figure 20).
IMPORTANT:
The control cable must contain some slack
when you disengage the control bar for the auger blades
to stop properly.
NOTE:
You may need to adjust the control cable from
position 1 (default) to position 2 if you notice belt slip
when the control bar is engaged.
NOTE:
If the control cable is adjusted to position 2,
ensure that the auger stops properly when the control bar
is released
Figure 22
1. Auger blades
2. Scraper bar
1
2
Adjusting the Control Cable
1. With the control bar disengaged, unhook and move
the control cable to the highest position. (Figure 21).
Figure 20
1. Control bar
1
1. Control bar
2. Adjuster link
3. Cable positions
Figure 21
1
2
3
Position 1: Default position
(Lower Hole as shown in illustration)
Position 2
Inspecting the Auger Blades/
Scraper Bar
Before each session, inspect the auger blades for wear.
When an auger blade edge or the scraper bar has worn
down have an Authorized Service Dealer replace the
auger blades and the scraper bar (Figure 22).
NOTE:
Auger blades and scraper bar are wear items and
may have to be replaced after extended use.
Summary of Contents for PR521ES
Page 19: ...19 SERVICE NOTES...
