8
NOTE:
This should allow the throttle trigger
to remain in the depressed position for start-
ing. You may want to practice this a few times
before you first start the unit.
S
DO NOT squeeze throttle trigger during
starting; otherwise, it will be necessary to
reset the throttle lock.
Choke
Primer Bulb
Starter
Handle
Choke
Primer Bulb
Starter
Handle
Muffler
COLD ENGINE STARTING (or warm
engine after running out of fuel)
S
Rest engine and shield on ground, support-
ing trimmer head off ground.
S
Move the ON/OFF switch to the ON posi-
tion.
S
Slowly press the primer bulb 6 times.
S
Move the choke lever to FULL CHOKE
position.
S
Set the throttle trigger in the starting position
using the throttle lock feature. Keep throttle
trigger in the starting position until engine runs
smoothly.
S
Pull starter rope handle sharply 6 times.
S
Move choke lever to HALF CHOKE posi-
tion.
S
Pull starter rope handle no more than 6
pulls, until engine runs.
S
Allow engine to run 10 seconds, then move
choke lever to OFF CHOKE position. Allow
unit to run for 30 more seconds at OFF
CHOKE before releasing throttle trigger
from the starting position. Release throttle
trigger by squeezing the trigger and then re-
leasing it.
STARTING A WARM ENGINE
S
Move the ON/OFF switch to the ON posi-
tion.
S
Move the choke lever to the OFF CHOKE
position.
S
Pull starter rope handle until engine runs.
S
If engine does not start in 5 pulls, follow in-
structions in STARTING A COLD ENGINE.
USING YOUR UNIT
OPERATING POSITION
Control Handle
in Right Hand
S
Extend your left arm and hold handlebar grip
with your left hand.
S
Hold throttle grip with your right hand with
finger on throttle trigger.
S
Keep unit below waist level.
S
Keep shoulder strap pad centered on your
left shoulder and danger sign centered on
your back.
S
Maintain full weight of tool on your left shoul-
der.
S
Without bending over, keep the blade or
trimmer head near and parallel to the ground
and not crowded into material being cut.
OPERATING INSTRUCTIONS FOR
USE WITH TRIMMER HEAD
Before trimming, bring engine to a speed suffi-
cient to cut material to be trimmed.
Do not run engine at a higher speed than neces-
sary. The cutting line will cut efficiently when the
engine is run at less than full throttle. At lower
speeds, there is less engine noise and vibration.
The cutting line will last longer and will be less
likely to “weld” onto the spool.
If the trimmer head does not turn when the en-
gine is in operation, make sure the drive shaft
housing is properly seated in engine shroud.
Always release the throttle trigger and allow
the engine to return to idle speed when not cut-
ting.
ADVANCING THE TRIMMER LINE
Advance line by tapping the bottom of the cutting
head lightly on the ground while engine is run-
ning at full speed. The line limiter blade (on un-
derside of shield) will cut the line to the proper
length..
WARNING:
Use only 0.080” (2 mm)
diameter line. Other sizes of line will not ad-
vance properly and can cause serious injury.
Do not use other materials such as wire,
string, rope, etc. Wire can break off during cut-
ting and become a dangerous missile that can
cause serious injury.