9
OPERATION
Drive speed control lever -
used to select forward or
reverse motion and speed of snow thrower.
Traction drive control lever -
used to engage power-pro-
pelled for ward or reverse motion of snow thrower.
Auger control lever -
used to engage auger motion (throw
snow).
Discharge chute control lever -
used to change the di-
rec tion the snow is thrown.
Skid plate -
used to adjust height of scraper bar from the
ground.
Toolbox -
used to store spare shear bolts, locknuts and
wrench.
Safety ignition key -
must be inserted for the engine to
start and run. Remove when snow thrower is not in use.
Recoil starter handle -
used for start ing the en gine.
Primer -
pumps additional fuel from the carburetor to the
cylinder for use when starting a cold engine.
Throttle/engine control -
used to se lect either FAST or
SLOW engine speed and to STOP the engine.
Choke control -
used for starting a cold engine.
MEETS A.N.S.I. SAFETY REQUIREMENTS
Our snow throwers conform to the standards of the American National Standards Institute.
TRACTION
DRIVE
CONTROL
LEVER
DISCHARGE CHUTE CONTROL LEVER
RECOIL
STARTER
HANDLE
THROTTLE
/ ENGINE
CONTROL
DRIVE SPEED
CON TROL LEVER
AUGER
CONTROL
LEVER
MUF FLER
TOOLBOX
HANDLE
KNOB
SKID PLATE
CHUTE
DE FLEC TOR
DISCHARGE
CHUTE
AU GERS
GAS O LINE
FILLER
CAP
ENGINE OIL CAP
WITH DIPSTICK
SPARK
PLUG
SAFETY
IGNITION
KEY
CHOKE
CON-
TROL
PRIM ER
FUEL SHUT-OFF VALVE
NOTE: ITEMS ABOVE
ARE SHOWN IN
THEIR TYPICAL
LOCATION ON THE
ENGINE. ACTUAL
LOCATION MAY VARY
WITH THE ENGINE
ON YOUR UNIT.
OIL
DRAIN
PLUG
FIG. 8
CLEAN-OUT TOOL
