Electric Actuator Installation Configurations
Direct Drive
External Mount
Internal Mount
A. Direct drive - install actuator on the direct drive coupler and install provided pin to prevent actuator from spinning.
B. External mount - install actuator on the jackshaft outside the damper air stream. Use a Pottorff actuator mounting bracket to prevent actuator
from spinning.
C. Internal mount - install actuator in the damper airstream. Use a Pottorff actuator mounting bracket to prevent actuator from spinning.
POTTORFF
®
5101 Blue Mound Road, Fort Worth, Texas 76106
www.pottorff.com
Information is subject to change without notice or obligation.
NOTE:
Dimensions in parentheses ( ) are millimeters.
Thermal
Insulated
Control
Damper
TICD-50
Series
March
2015
The following installation details apply to models
TICD-50 Series, TICD-50BF Series, TICD-50BFX Series
thermally insulated control damper
installation instructions
Bracket
Direct Drive Coupler
Set Screw
#10 tek Screw
Manual Locking Quadrant
To install a manual locking quadrant:
A. Slide the manual locking quadrant on to the drive axle direct drive coupler (Fig. 8)
B. Tight the set screw
C. Secure with minimum one #10 tek screw on to the pre-installed bracket
Fig. 8
LEFT
DAMPER
MIDDLE
DAMPER
RIGHT
DAMPER
3 WIDE X 1 HIGH
1 WIDE X 3 HIGH
3 WIDE X 3 HIGH
TOP
DAMPER
MIDDLE
DAMPER
BOTTOM
DAMPER
TOP
LEFT
DAMPER
TOP
MIDDLE
DAMPER
TOP
RIGHT
DAMPER
MIDDLE
LEFT
DAMPER
MIDDLE
DAMPER
MIDDLE
RIGHT
DAMPER
BOTTOM
LEFT
DAMPER
BOTTOM
MIDDLE
DAMPER
BOTTOM
RIGHT
DAMPER
Configuration 3 wide x 1 high may have the Middle Damper quantity greater than 1.
Configuration 1 wide x 3 high may have the Middle Damper quantity greater than 1.
Configuration 3 wide x 3 high may have the (Middle Left Damper, Top Middle Damper,
Middle Damper, Bottom Middle Damper, Middle Right Damper) quantity greater than 1.
Multiple sections configurations - extended mounting flange examples shown:
