GB
WORKING POSITION
- 11 -
arBEiTSSTELLUNG 00-GB (28)
Preparing for operation
Caution!
Do not enter rotor area while driving motor is
running.
1. Install all tine arms onto both rotors.
• Place tine bearers (1a) onto rotor arms and secure with
linch pin (V).
2. Swing guard rails (6), left and right, outward and secure
with spring pin (6a).
Adjustment of the working width
Depending on the crop conditions and to adapt the machine to
the following implements (chopper, self-loading forage waggon),
it is possible to vary the machine working width between 7 and
7,8 m.
Altering the working width (A1 - A2)
• stop valve opened
(Pos. E)
• actuate double-action
control unit (ST)
Important!
Grease the sliding surfaces occasionally.
TD 44/94/15
a2
a1
