2. Use a stud-finder to determine if the mark of Step (1) happens to align with a wall stud or not. If it does, do not use the
anchor as the provided anchor cannot penetrate wood studs. In this instance, use a Philips screwdriver to secure a
screw directly into the wall and stud at that mark. Rotate the screw clockwise until the screw head is about 3/8 inch
from the wall.
3. If the mark does not align with a wall stud, first install an anchor. To install the anchor, use a Phillips screwdriver to
engage an anchor and then position the anchor tip against the wall at that mark. Rotate the anchor clockwise as you
firmly push it into the wall. The anchor will drive itself into the wall like a large screw. Continue rotating until the flange
of the anchor becomes even with the wall surface. Do not over-tighten.
4. Insert a screw into the installed anchor and use the screwdriver
to rotate the screw clockwise until the screw head is about 3/8
inch from the wall.
5. Lift the clock against the wall and engage the keyhole bracket
with the protruding screw head. Gently lower the clock so that
the screw supports its full weight.
CARE INSTRUCTIONS
-
Wipe with soft, dry cloth.
-
Do not use abrasive or strong chemical household cleaners.
Thank you for your purchase!
stores | catalog | www.potterybarn.com
or
Mounting Hardware Installation
