3-2.
Install the Power Adapter
The system is equipped with a 90W power adapter. Please plug it into the system as
shown below.
Turn off the system:
1.
Hold down the power button for 5 seconds to bring up the "Slide to shutdown"
screen.
2.
To force a hard
shut down
, h
old down the power button for 10 seconds
.
WARNING:
This can cause data loss and render the system inoperable.
* When the power adapter is connected, the power LED on
the
printer indicator will
blink slowly
.
1.
Follow the steps
described
in Chapter 3-1 to open the
rear
cover first.
2.
Place the system face down to access the bottom of the
base
.
3.
Thread the power adapter cable through the hole of the stand as shown in the
picture.
4.
Find the power connector on the right of the I/O panel (refer to chapter 2-3 b.) and
plug
the power adapter
in
to the DC-IN connector
with the flat side facing the terminal
.
5.
Finally arrange and
secure
the cable by as shown in the picture.
Warning:
• Please follow the direction
s
when
connecting
the adapter and make sure it is fully
connected
into the I/O port.
• When attaching or detaching the cable, do so by holding the connector, not the
cable itself.
•
DO NOT
pull or rotate the cable which may cause damage to the
port
.
Turn the system
on
:
1. Located the power button on the bottom left corner of the screen.
Hold down the
power button for
3
seconds to
power on the system.
6
