the power supply unit of the PC. Check the power switch on base of PD2500
should be turned off. Connect the 4 pin plug of cable 20863041100 to the
jack in the I/O plate and connect the power plug to the jack above the 9 pin
D connector at one side of PD2500 base. Use the attached interface cable
20863035900 (CCBLA-359) to connect the 9 pin female connector at side of
the base of PD2500 to the 9 pin male connector for serial port such as COM1
of the host PC.
5.
For Posiflex POS powered PD2500:
Adjust the internal jumper of the
Posiflex POS system to supply 5 V DC to the selected COM port. Use the
attached interface cable 20863037200 (CCBLA-372) to connect the 9 pin
female connector at side of the base of PD2500 to the 9 pin male connector
for serial port of the Posiflex POS system.
6.
For Posiflex Jiva XL powered PD2501:
Adjust the internal
jumper of the Posiflex Jiva XL system to supply 5 V DC to the
COM port connected. Open the rear connect area and assemble
the base of PD2501 into the opening according to the instruction given for
Jiva XL. Connect the 9 pin female connector of the cable coming from
bottom of PD2501 to the 9 pin male connector for serial port of the Jiva XL.
7.
For all PD2500 & PD2501:
Turn on the Jiva XL, Posiflex POS system, the
PC connected and the power switch of PD2500 models, a firmware version
as power on sign will appear for a while to indicate that PD2500 is tested
O.K. and ready to work.
IV. COMMAND EMULATION
This customer display supports totally 6 emulation modes. The emulation
mode is selected by adjusting when power turned off the BIT 3, 4 and 5 of the
DIP SW1 on the back according to this table. It is turned ON when pushed up.
Mode UTC
Aedex
Noritake Epson Futaba ADM
SW1 BIT 3
ON ON ON ON OFF OFF
SW1 BIT 4
ON ON OFF OFF ON ON
SW1 BIT 5
ON OFF ON OFF ON OFF
This unit is set to Noritake mode as delivered. For more details of each
emulation mode, please refer to the Product Information CD or visit our web site
http://www.posiflex.com.tw for latest updates.
3
