Part 9
over.
This electronic key switch is delivered with a set of 4 pcs of keys,
each marked as “PRG”, “REG”, “Z” and “GT”. The effective range of each of
the 4 keys can be illustrated by the following table and drawing.
PRG REG
Z GT
LP Y N N N
L0 Y Y Y Y
L1 Y Y Y Y
L2 Y Y Y Y
L3 Y N Y Y
L4 N N N Y
Programmable Keys
The multi-page programmable keys can deliver to the host system the
string of keyboard input as programmed. Please note that when the 6 position
electronic control key is turned to a different position, the content of same key
could be completely different. It is also possible to use combination keys if
programmed to. There will be no output of these keys if the control key is
turned to “L0” position.
Numerical Keypad
The numerical keypad is durably pre-marked. When the 6 position
electronic control key is turned to a different position, the content of same key
remains unless it has been programmed in a particular way. The numerical
keypad is not applicable in combination keys. There will be no output of these
keys if the control key is turned to “L0” position.
DOS Application Notice for KP-200U / KP-210U
The keypad KP-200U/ KP-210U connects to the host through USB
port working as a USB KB and therefore also requires no driver installation
except
setting up the USB keyboard to be enabled in system BIOS CMOS
setup
. This setup is particularly important for application of the USB KB
device to operate under DOS environment. Please note that the KP-200U / KP-
210U delivered particularly for DOS environment application is different from
that for Windows environment by internal jumper setting or circuitry and
therefore they are not freely interchangeable for end users.
MAGNETIC STRIPE READER (OPTION)
For magnetic stripe card reading, be sure to insert the card to the
bottom with magnetic stripe facing the mark aside the slot. The movement of
the card can be either inserting the card from the top surface then sliding the
card down out of the slot, or sliding the card upward from the lower side of the