POSGEN
Roger Beep
In the standby mode, press the Menu/monitor button 5 times. Then it goes to Roger Beep selection mode.
Pressing the Up/Down arrow button, you can select on or off of the roger beep tone. To exit and go to
standby mode, press the PTT button momentary.
Call Selection
In the standby mode, press the Mode/Monitor button 6 times. Then it goes to Call melody selection mode.
Pressing the Up/Down arrow button, you can select 3 different call tones. Select your desired melody and
press PTT button to goes to standby mode.
External Speaker (SPK)/Microphone (MIC) Jacks
This set of jacks accepts an headset/microphone connector for hand-free operation.
1. Insert the plugs into the SPK/MIC jacks.
2. Place the earbud into your ear, and adjust the Mic into your desired position.
Channel Scan Operation
This feature allows you to monitor all main channels automatically for valid signals While scanning, you can
transmit and receive. When a signal is received, the scan is interrupted. Press Scan button to resume
scanning.
To enable the channel scan mode,
-From standby mode, press the SCAN Button;
-The radio will display each channel (1-22) number in order as the scan mode operates to find an
active main channel.
-When unit does not find any signals, and you want to transmit, press the PTT switch to return to the
channels you originally selected. If there is no signals for 5 seconds after the communication is
completed, the unit will resume scan automatically.
-When you want to leave the scan mode, press the SCAN button momentarily. Then, the unit will
return to normal operation;
Key Lock
The purpose of the lock function is to lock most buttons to avoid accidental operation. To engage the lock
function, push and hold the Scan/Lock button for 2 second. An audible tone will confirm lock function.
To unlock, push and hold the Scan/Lock button for 2 second until disappear the lock Icon on LCD display.
Battery AIert
When the battery icon blinks on the LCD panel and heard warning beep tone, recharge unit or install fresh
batteries.
Notes for good communication :
1. Your radio has been designed to maximize performance and improve transmission range in the open field.
To avoid interference, it is recommended that you do not use the units closer than 5 feet apart.
2. For best transmission results, always keep your mouth about 2-3 inches from the microphone and speak
slowly in a normal voice.
3. To increase battery life, avoid features such as Scan. This feature will reduce operating time considerably.