▪ Reassemble the motor unit (connect with the coupling).
▪ Tension the V-belts as shown in the previous section "Changing the V-belts on a PTO
drive".
▪ Affix the guard plates.
Before operating, all protective guards must be attached to the machine.
Oil changing
Old oil must be disposed of in an environment-friendly manner. Find out about the
environmental regulations in your country.
Changing the hydraulic oil
The first oil change should be carried out after 1000 operating hours or annually.
1
2
3
1
Vent screw
3
Oil sight glass
2
Oil drain screw
▪ Remove the ventilation screw.
▪ Open the oil drain screw.
The oil drain screw is located on the base of the oil tank.
▪ Drain the old hydraulic oil into a container.
▪ Screw the oil drain screw back into the tank and fill with new hydraulic oil through the
ventilation screw opening.
See also ..... Hydraulic oil level [➙ 36]
▪ Screw the ventilation screw into the tank.
▪ Turn on the machine and allow it to run for a short while.
▪ Check the oil level and top up hydraulic oil if necessary.
Total filling capacity of the hydraulic system:
Quantity
25 litres
Please note that the information here concerns initial oil filling. Depending on the type
and variant, the refill quantity may be slightly less (as some of the hydraulic components
are not empty).
Our hydraulic system is filled with high-quality OMV ATF II transmission fluid.
9.4
9.4.1
Maintenance
43
