Information of use of the
LED Power Supply
Model No.:
FTPC100V12-E
FTPC100V24-E
Specifications
Applications
Important information for the installation
Mounting instruction
~200-240VAC / 50/60Hz / PF
ł
0.9 / Ta=45°C /
Tc=90°C / IP20
Model No.
DC Voltage
FTPC100V12-E
FTPC100V24-E
12V
24V
0-100W
0-100W
< 0.7A
< 0.7A
8.33A
4.17A
100W max.
100W max.
Load
Input Current
Max. Output Power
Rated Current
An electronic protection circuit switches off the power supply in case of short circuit or overload in
ź
the secondary circuit, overheat as well as open circuit. After the removing of the faults, the LED
power supply is resetting automatically for operation again.
ź
voltage directive
2014/35/EU
.
The unit conforms to the directive
2014/30/EU
for the electromagnetic compatibility and the low
Connect the LED lamps to
ź
LED power supply according
to the schematic drawing.
Primary cable:
ź
2
H03VVH2-F 2x0.75mm
Secondary cable:
ź
2
H05VVH2-F 2x1.0mm
Be sure to read and understand all instructions before installation. For best results have installed by a
ź
qualified technican.
You must connect load to the power supply first before connecting power supply to mains. Improper
ź
order connection may cause damage and will void warranty.
There are no user serviceable parts inside power supply. Do not open power supply.
ź
Do not overload the power supply. Suitable for use in Dry Locations.
ź
The maximum length of output cable to the LED lamps should not exceed 2m in order to meet the
ź
EMC standards.
If the LED power supply is used for purposes other than originally intended or it is connected in the
ź
wrong way, no liability can be taken over for possible damages.
5±0.5kgf.cm
Mounting Location Dimension
R1.0, 13.03.2018
POS POWER
MPL Power Elektro Sp. z o.o.
ul. Wschodnia 40
44-119 Gliwice
Input terminals
PRI
phase
L
neutral
N
Output terminals
SEC
Positive
+
Common
-
