Section 8 - Removal & re-fitting the stove throat plate
If in doubt contact a competent person
8.1
Ensure the stove is cool.
8.2
Remove the front fuel grate (as shown in figure 7 below) by lifting clear from the
lugs. Lift the vermiculite baffle which in turn will allow the side liners and the
baffle to be removed from the stove.
8.3
Caution – the throat plate is heavy and needs to be supported during removal.
To remove (1) rotate the throat plate upwards, (2) slide backwards and (3) pull
downwards to release.
Clean off any fly ash etc. If using throat plate removal as access to the
chimney. Please ensure that all debris is completely removed prior to refitting the
throat plate.
8.6
Ensure that throat plate location areas are clear and then re-fit the throat plate
and side board retaining brackets in reverse order. (It is essential that the throat
plate is located as shown in figure 8).
8.7
On subsequent start-up, check the stove for correct performance and clearance of
combustion products.
Fig. 7
Fig. 8
Lift the front fuel
retaining grate
clear from the
lugs
Page 15 of 17
To remove the throat plate, (1) rotate upwards, (2) slide
backwards and (3) pull downwards to release
Lift the vermiculite
baffle to allow the
side liners to be
removed
(1)
(2)
(3)
