Deleting a channel
Set the channel that You wish to delete.
1.Press P2 button, the motor will emit a single sound and will vibrate.
2.Press the STOP button. The motor will only emit a single sound.
3.Press again P2 button. The deleting procedure will be confirmed by 4 short beeps and
after that the motor will vibrate, meaning that the deleting was successful.
CAUTION !!!
If the settings of one channel will be deleted then all the motors that have been
programmed on this channel will be deleted as well. Each deleting and further
programming procedure requires the power to be switched on for each motor
individually, that is why it is recommended that each motor has its own power
supply separately assigned.
Adding another transmitter/channel
The procedure of adding a new transmitter/channel starts with the already working
transmitter. When adding a new transmitter/channel the power supply does not need to
be switched off and on again.
Set the channel that You want to add on a new transmitter.
1.Press P2 button on the already existing transmitter, the motor will emit a single sound
and will vibrate.
2.Press the P2 button again. The motor will only emit a single sound.
3.Now select the transmitter/channel on the new device and press P2 button ( or Up +
STOP buttons simultaneously, depending on the transmitter ). The motor confirms
by beeping 5 times. The new channel/transmitter is programmed.
P2
MODE
TIME
2x
P2
MODE
TIME
P2
MODE
TIME
P2
MODE
TIME
!!!
3
