Page 13
For technical questions, please call 1-888-866-5797.
Item 63254
S
AFET
y
Op
ERA
TION
M
AINTENAN
c
E
S
ETU
p
cleaning Windows
a. Inspect caulking and/or glazing. Inspect trim.
DO NOT pRESSURE WASH WINDOWS IF
cAULKING/GLAZING/TRIM IS NOT INTAcT.
b. If needed, apply detergent according
to manufacturer's instructions.
c. Set Nozzle to low-impact fan spray.
DO NOT USE HIGH-IMpAcT SpRAy,
FORcE MAy BREAK GLASS.
d. Point Spray Gun at 45° angle to, and 4 feet
away from, window. Spray window.
cleaning Wood
DO NOT cLEAN WOOD THAT IS
HOT OR IN DIREcT SUNLIGHT.
a. If needed, apply wood cleaning
detergent according to manufacturer's
instructions. For vertical surfaces,
apply detergent from bottom to top.
b. Scrub stained areas as needed.
c. Set Nozzle to low-impact fan spray.
d. Point Spray Gun at 45°. Spray surface,
working with the grain of the wood.
e. Let surface dry completely, then apply
stain or sealer, as needed, according
to manufacturer's instructions.
cleaning Brick and Mortar
a. Inspect mortar, patching as needed. Let mortar
cure according to manufacturer's instructions.
b. Soak surface prior to applying detergent.
c. If needed, apply brick cleaning
detergent according to manufacturer's
instructions. For vertical surfaces,
apply detergent from bottom to top.
d. Scrub stained areas as needed.
e. Set Nozzle to low-impact fan spray.
TO pREVENT DAMAGE, ONLy
USE LOW-IMpAcT SETTING.
f. Point Spray Gun at 45°. Spray surface.
g. Let surface dry completely, then
apply sealer, as needed, according to
manufacturer's instructions as needed.
7. When finished:
• Release Trigger, then set Trigger Safety Lock.
• Turn off Power Switch.
• Turn off water supply.
• Unplug the unit.
• Point Spray Gun in safe direction, press Trigger
to release all pressure, then release Trigger.
• Disconnect water supply hose.
• Disconnect High-Pressure Hose from unit.
• Disconnect High-Pressure
Hose from Spray Gun.
8.
IMpORTANT: cLEAN THE NOZZLE AFTER
EVERy USE TO MAINTAIN SpRAyING
pOWER AND pREVENT pUMp DAMAGE.
• Remove Wand from Spray Gun.
• Remove Nozzle from Wand by
turning Nozzle clockwise.
• Twist Nozzle to expose tip.
Blades
Nozzle
Tip
• Push Nozzle Tip Cleaner into tip to
push out debris and buildup.
• Remove Nozzle Tip Cleaner and
back-flush water through Nozzle.
• Reattach Nozzle to Wand.
• Clean and store according to
User-Maintenance Instructions on page 14.
