RIGIDITY ADJUSTMENT
TO ADJUST THE GOAL RIGIDITY, FIRST USE A #2 PHILLIPS HEAD SCREWDRIVER TO
REMOVE THE RUBBER COVER ON THE BOTTOM OF THE GOAL TO EXPOSE THE GOAL'S
SPRING MECHANISMS. PLACE A SOCKET WRENCH WITH A 1" SOCKET ONTO THE REAR,
THIN NUT UNDERNEATH THE RED SPRING. FROM ABOVE THE GOAL, PLACE A 5/16" ALLEN
WRENCH THROUGH THE OPEN HOLE ON TOP OF THE GOAL PLATE UNTIL IT FITS INTO THE
SOCKET HEAD BOLT. TIGHTEN OR LOOSEN THE NUT (COMPRESSING OR RELAXING THE
RED SPRING) TO ADJUST THE RIGIDITY READING OF THE GOAL. ONCE COMPLETE,
REPLACE THE RUBBER COVER AND THE COVER BOLTS.
WARNINGS: THE THIN NUT MUST MAINTAIN ALL THREADS FULLY ENGAGED ON THE LARGE
BOLT; FAILURE TO DO SO COULD RESULT IN FAILURE OF THE GOAL AND SEVERE INJURIES
COULD OCCUR. ALSO, DO NOT MAKE ADJUSTMENTS TO THE NUT UNDER THE GOLD SPRING.
www.porterathletic.com
Copyright
2019 by Porter Athletic.
All rights reserved.
888-277-7778
9/10/2019
INST280180
Page 3 of 4
280180
PORTER TFX 180 BREAKAWAY AND FLEX GOAL
GOAL INSTALLATION AND ADJUSTMENT INSTRUCTIONS
