4. Push down the switch handle (3) and pull out the head
lock knob (4).
5. Gently release the downward pressure and allow the
arm to rise to its full height, remove the foam (5) under
the motor.
6. Holding the miter lock handle (2) while press down on
the miter detent lock lever (6), to move the table to 0°,
tighten the miter lock handle.
7. Unlock the bevel lock handle (7), tilting cutting arm to
0°, tighten bevel lock handle.
ASSEMBLY AND ADJUSTMENTS
Estimated Assembly Time: 2 Minutes
ASSEMBLY INSTRUCTIONS
WARNING
To avoid injury, do not connect this miter saw to a power
source until it is completely assembled and adjusted and
you have read and understood the operator’s manual.
WARNING
To reduce the risk of injury, turn unit off and disconnect
An accidental start-up can cause injury.
WARNING
Always make sure the miter saw is securely mounted to
a workbench or approved workstand. Failure to heed this
warning can result in serious personal injury.
CAUTION
Many of the illustrations in this manual show only portions
of the miter saw. This is intentional so that we can clearly
show points being made in the illustrations. Never operate
the saw without all guards securely in place and in good
operating condition.
1. Remove the saw from the packing material carefully
using the carrying handle (1). Place the saw on a
smooth, flat surface such as a workbench or strong
table.
2. This saw has been shipped with the miter table 48°
right & cutting arm bevel 15° left and the saw arm
secured in the down position.
3. Assemble miter lock handle (2) to the miter saw control
arm.
14
1
2
4
5
3
1
6
2
2
1
