21
)LJ6
7RDYRLGLQMXU\IURPDQDFFLGHQWDOVWDUW
PDNHVXUHWKHVZLWFKLVLQWKH2))SRVLWLRQ
DQGWKHSOXJLVQRWFRQQHFWHGWRWKHSRZHU
source outlet.
%HYHO3RLQWHU$GMXVWPHQW)LJ7
1. When the blade is exactly 90° (0°) to the
table, loosen the bevel indicator screw (1)
using a Phillips screwdriver.
2. Adjust bevel pointer (2) to the “0” mark
on the bevel scale and retighten the
screw (1).
)LJ7
7RDYRLGLQMXU\IURPDQDFFLGHQWDOVWDUW
PDNHVXUHWKHVZLWFKLVLQWKH2))SRVLWLRQ
DQGWKHSOXJLVQRWFRQQHFWHGWRWKHSRZHU
source outlet.
%HYHO6WRS$GMXVWPHQW)LJ5
1. Set the miter angle to zero degree.
2. Loosen the bevel lock handle (1) and tilt
the cutting arm completely to the left.
8VLQJDFRPELQDWLRQVTXDUHFKHFNWRVHH
if the blade is 45° to the table.
4. If the blade is not at 45° to the miter table,
tilt the cutting arm to zero degree, loosen
the lock nut (7) and turn the bolt (8) in
or out accordingly with an adjustable
wrench.
5. Tilt the cutting arm back to the left and
recheck alignment.
4
5
1
2
6. Repeat above steps until the blade is
45° to the table. Once alignment is
achieved, tighten the lock nut (7) to
secure the bolt (8).
MITER SCALE (FIG. U)
The miter saw scale can be easily read,
showing miter angles from 0° to 48° to the
left, and 0° to 55° to the right. The miter saw
table has positive stops at most common
angle settings at 0°, 15°, 22.5°, 31.6°, 45°
right & left, and 55° right. These positive stops
SRVLWLRQWKHEODGHDWWKHGHVLUHGDQJOHTXLFNO\
and accurately. Follow the process below for
TXLFNHVWDQGPRVWDFFXUDWHDGMXVWPHQWV
0LWHU$QJOHV$GMXVWPHQW
1. Unlock the able by turning the miter
handle (1) counterclockwise.
2. Move the turntable while lifting up on
the positive stop lock lever (2) to align
the miter scale pointer (3) to the desired
degree measurement.
3. If the desired angle is one of the ten
positive stops, release the positive stop
lock lever (2), making sure the lever
snaps into position, and then secure by
tightening the miter handle (1).
4. If the miter angle desired is not one of
the ten positive stops, simply lock the
miter table into desired angle position
by turning the miter handle (1) in the
clockwise direction.
0LWHU$QJOH3RLQWHU$GMXVWPHQW
1. Move the table to the 0° positive stop.
2. Loosen the screw (4) that holds the
pointer (3) with a Phillips screwdriver.
3. Adjust the pointer (3) to the 0° mark and
retighten the screw.
)LJ8
1
2
3
4
WARNING
!
WARNING
!
