Porter-Cable PCC640 Instruction Manual Download Page 6

6

IMPORTANT SAfETy INSTRUCTIONS fOR BATTERy CHARGERS

SAVE THESE INSTRUCTIONS: 

This manual contains important safety instructions for 

battery chargers.

WARNING:

 Before using charger, read all instructions and cautionary markings on 

charger, battery pack, and product using battery pack.

•  

Shock hazard.

 Do not allow any liquid to get inside charger. 

•  

Burn hazard. 

To reduce the risk of injury, charge only designated 

PORTER-CABLE 

 

batteries. Other types of batteries may burst causing personal injury and damage.

•  Under certain conditions, with the charger plugged in to the power supply, the charger 

can be shorted by foreign material. Foreign materials of a conductive nature such as, 

but not limited to, steel wool, aluminum foil, or any buildup of metallic particles should 

be kept away from charger cavities. Always unplug the charger from the power supply 

when there is no battery pack in the cavity. Unplug charger before attempting to clean.

•  

DO NOT attempt to charge the battery pack with any chargers other than the ones in 

this manual.

 

The charger and battery pack are specifically designed to work together.

 

•  

These chargers are not intended for any uses other than charging designated 

PORTER-CABLE  rechargeable batteries.

 

Any other uses may result in risk of fire, 

electric shock or electrocution.

•  

Do not expose charger to rain or snow.

•  

Pull by plug rather than cord when disconnecting charger. 

This will reduce risk of 

damage to electric plug and cord.

•  

Make sure that cord is located so that it will not be stepped on, tripped over, or 

otherwise subjected to damage or stress.

•  

Do not use an extension cord unless it is absolutely necessary.

 

Use of improper 

extension cord could result in risk of fire, electric shock, or electrocution.

•  

An extension cord must have adequate wire size (AWG or American Wire Gauge) 

for safety.

 

The smaller the gauge number of the wire, the greater the capacity of the 

cable, that is 16 gauge has more capacity than 18 gauge. When using more than one 

extension to make up the total length, be sure each individual extension contains at 

least the minimum wire size.

•  

Do not place any object on top of charger or place the charger on a soft surface 

that might block the ventilation slots and result in excessive internal heat. Place 

the charger in a position away from any heat source.

 

The charger is ventilated 

through slots in the top and the bottom of the housing.

•  

Do not operate charger with damaged cord or plug —

 

have them replaced immediately.

•  

Do not operate charger if it has received a sharp blow, been dropped, or 

otherwise damaged in any way. 

Take it to an authorized service center.

•  

Do not disassemble charger; 

take it to an authorized service center when service 

or repair is required. Incorrect reassembly may result in a risk of electric shock, 

electrocution or fire.

•  

Disconnect the charger from the outlet before attempting any cleaning. 

This will 

reduce the risk of electric shock. Removing the battery pack will not reduce this risk.

•  

NEVER attempt to connect 2 chargers together.

•  

The charger is designed to operate on standard household electrical power (120 

Volts). Do not attempt to use it on any other voltage. 

SAVE THESE INSTRUCTIONS

IMPORTANT SAfETy INSTRUCTIONS fOR BATTERy PACkS

WARNING:

 

For safe operation, read this manual and manuals originally supplied 

with tool before using the charger.

The battery pack is not fully charged out of the carton. Before using the battery pack and 

charger, read the safety instructions below. Then follow charging procedures outlined.

READ ALL INSTRUCTIONS

Summary of Contents for PCC640














Reviews: