Porter-Cable PCB660DP, Instruction Manual

Page: 20 / 28

20
OPERATION
BASIC DRILL PRESS OPERATION
To avoid possible injury, keep guard closed
and in place while tool is in operation.
To avoid injury from an accidental start,
ALWAYS make sure the switch is in the “OFF”
position, the switch key is removed, and the
plug is not connected to the power source
outlet before making belt adjustments.
SPEEDS AND BELT PLACEMENT (FIG. V)
The drill press has 12 speeds, see the chart
in Fig. V to select the correct belt placement
for your project.
Fig. V
300RP M
390 450
990 550 1 620 1
560 640 700
900
1
620 2 100 3
RP M RP M
RP M
RP M RP M
RP M RP M
RP M
RP M RP M
RP M
DRILLING SPEED TABLE (RPM)-FOR 15 IN. (381 MM) DRILL PRESS
Drill Dim.
Inches
(mm)
Material
Wood Aluminum Plastic Mild Steel Stainless
1/32
(0.7 mm)
3100
3100 3100
3100
3100
1/16
(2.5 mm)
1620-2620
1/8
(3.18 mm)
1620-2620 990-1550
3/16
(4.8 mm)
990-1550 640-700
1/4
(6.4 mm)
1620-2620 1620-2620
5/16
(7.9 mm)
640-700 390-560
3/8
(9.5 mm)
990-1550 990-1550
7/16
(11.1 mm)
1620-2620 390-560
300
1/2
(12.7 mm)
640-700 640-700
9/16
(14.3 mm)
5/8
(15.9 mm)
WARNING
!
ON / OFF SWITCH PANEL (FIG. W)
The “ON / OFF” switch has a removable
safety key. With the key removed from the
switch, unauthorized and hazardous use by
children and others is minimized.
1. To turn the drill press “ON,” insert the key (2)
into the slot of the switch (1), and move the
switch upward to the “ON” position.
2. To turn the drill press “OFF,” move the
switch (1) downward.
3. To lock the switch in the OFF position,
grasp the sides of the safety key (2), and
pull it out.
4. With the safety key removed, the switch
will not operate to power the drill press on.
5. If the safety key is removed while the drill
press is running, it can be turned “OFF”
but cannot be restarted without inserting
the safety key.
6. To turn the laser “ON,” press the rocker
switch (3) to the on position.
7. Never leave the drill press unattended.
Turn the laser switch and power switch
“OFF” and wait until it comes to a
complete stop, and remove the safety key
to prevent unauthorized starts.
ALWAYS lock the switch “OFF” when the
drill press is not in use. Remove the key
and keep it in a safe place. In the event
of a power failure, blown fuse, or tripped
circuit breaker, turn the switch “OFF” and
remove the key, preventing an accidental
startup when power comes on.
Fig. W
2
1
3
WARNING
!