4
Wear appropriate hearing protection during use.
Under some
conditions and duration of use, noise from this product may contribute to hearing loss.
Spark deflector will get hot. Avoid touching or adjusting while hot. Keep
cordset and materials away from spark deflector.
Some dust created by power sanding, sawing, grinding, drilling, and
other construction activities contains chemicals known to the State of California to cause
cancer, birth defects, or other reproductive harm. Some examples of these chemicals are:
• lead from lead-based paints,
• crystalline silica from bricks and cement and other masonry products, and
• arsenic and chromium from chemically-treated lumber (CCA).
Your risk from these exposures varies, depending on how often you do this type of work.
To reduce your exposure to these chemicals: work in a well ventilated area, and work with
approved safety equipment, such as those dust masks that are specially designed to filter
out microscopic particles.
•
Avoid prolonged contact with dust from power sanding, sawing, grinding,
drilling, and other construction activities. Wear protective clothing and wash
exposed areas with soap and water.
Allowing dust to get into your mouth, eyes, or
lay on the skin may promote absorption of harmful chemicals.
Always use NIOSH/OSHA approved respiratory protection appropriate for
the dust exposure. Direct particles away from face and body.
For your convenience and safety, the following warnings are on your Heavy-Duty 14 inch
(355mm) Chop Saw:
FOR SAFE OPERATION READ THE INSTRUCTION MANUAL.
•
DO NOT USE TOOTHED BLADES.
•
USE ONLY REINFORCED WHEELS RATED 4100 RPM OR HIGHER.
•
WHEN SERVICING USE ONLY IDENTICAL REPLACEMENT PARTS.
•
ALWAYS: WEAR EYE PROTECTION, USE GUARDS, CLAMP WORK IN VISE, USE
PROPER RESPIRATORY PROTECTION.
•
DO NOT EXPOSE TO RAIN OR USE IN DAMP LOCATIONS.
•
ONLY USE CHOP SAW WHEEL OF A MAX. THICKNESS OF 2.8mm AND A
MAX. DIAMETER OF 14 INCHES (355mm).
The label on your tool may include the following symbols. The symbols and their
definitions are as follows:
V ..................volts
A ..................amperes
Hz................hertz
W..................watts
min ..............minutes
................alternating current
..........direct current
no ................no load speed
................Class I Construction
..................earthing terminal
(grounded)
................safety alert symbol
................Class II Construction
.../min or rpm..revolutions or reciprocation
(double insulated)
per minute
:
:
:
:
:
2.8
355
MAX. mm
90547095 PC14CTSW 6/24/09 10:06 AM Page 4
