13. Do not charge battery pack
when the temperature is BELOW
or ABOVE 40°C. This is
very important for proper operation.
14. Do not incinerate battery pack.
It can explode in a fire.
15. Do not charge battery
in damp or wet locations.
16. Do not attempt
to charge any other cordless tool or battery pack with the FLEX charger.
17.
Do not short across
the terminals of the battery pack: EXTREMELY HIGH TEMPERATURES
COULD CAUSE PERSONAL INJURY OR FIRE.
18. Dispose of expended batteries properly.
The FLEX Battery Pack
contains rechargeable, nickel-cadmium batteries. These batteries
must be recycled or disposed of properly. Drop off expended battery
packs at your local replacement
battery
retailer or your local recycling
center.
FUNCTIONAL DESCRIPTION
SWITCH OPERATION
Squeeze trigger switch (A) Fig. 1, to start motor. Release trigger to stop motor. As the trigger is
squeezed the motor speed increases.
NOTE:
A low volume, high pitched tone may
be
heard while the switch is in the variable
speed mode. This is normal.
FORWARD/REVERSE
l
Make sure trigger switch (A) Fig. is in OFF position before attempting to change direction of
rotation.
l
Push button (B) Fig. toward left side of drill for FORWARD (clockwise) rotation.
. Push button (B) Fig. toward right side of drill for REVERSE (counterclockwise) rotation.
l
Place button (B) Fig. 1, in center position to lock trigger switch in OFF position.
ELECTRIC BRAKE
When the trigger switch is released, an electric brake automatically engages to stop spindle
rotation.
INSTALLING AND REMOVING DRILL AND SCREWDRIVER BITS
CAUTION:
Always set reversing button to center (locked OFF) position when installing and
removing bits.
2. The three-jaw
chuck
is designed for
of the bit. Open jaws large enough
by
turning
outer sleeve (A) Fig. 2, counterclockwise, when viewing the chuck from the bit end, so that bit shank
can be inserted easily.
3. Clean and insert smooth end of bit as far as it will go into the chuck, or up to the flutes for
small bits.
4. While holding the bit with one hand, turn outer sleeve (A) Fig. 2, clockwise until the bit is
gripped in the chuck.