3%,%#4).'4(%")4
-ODELS AND ACCOMMODATE BITS WITH DIAMETER SHANKS THAT ARE
INSTALLEDDIRECTLYINTOTHEPOWERUNITCOLLET#OLLETSAREAVAILABLETHATWILLALLOWTHE
USEOFBITSHAVINGORDIAMETERSHANKS
$/.453%ROUTERBITSWITHADIAMETERINEXCESSOF
EXCEPT WHEN USING -ODEL MOTOR SET FOR EITHER
OR20-2OUTERBITSWITHADIAMETERUPTOMAYBEUSED
WITH THE MOTOR OPERATING IN THE OR 20- SPEEDS
2OUTERBITSWITHADIAMETERUPTO
MAYBEUSEDWITHTHEMOTOR
OPERATINGINTHE20-SPEED
/0%2!4)/.
).34!,,).'!.$2%-/6).'4(%")4
$ISCONNECTTOOLFROMPOWERSOURCE
4OREMOVEMOTORUNITFROMBASEUNIT
A /PENTHECLAMP! &IG
B 7 H I L E H O L D I N G B A S E
T U R N
M O T O R
U N I T
# / 5 . 4 % 2 # , / # + 7 ) 3 %
UNTIL LOWER PIN " IN MOTOR
HOUSING IS DISENGAGED FROM
GROOVEINBASE
C ,IFTPOWERUNITFREEFROMBASE
UNIT
#LEAN AND INSERT SHANK OF BIT
INTO COLLET AT LEAST )F SHANK
hBOTTOMSv IN ROUTER THEN BACK IT OUT APPROXIMATELY TO ALLOW PROPER
TIGHTENING
,AYTHEPOWERUNITONITSSIDEONABENCHWITHTHECOLLETPOINTING!7!9FROM
YOU
0LACE ONE WRENCH ON FLATS ON
CHUCK WITH THE OPPOSITE END
OF THE WRENCH RESTING ON THE
BENCHTOYOURLEFT&IG
0 L A C E O T H E R W R E N C H
O N C O L L E T A N D T I G H T E N
#/5.4%2#,/#+7)3% AS
SHOWN IN &IG 4)'(4%.
3%#52%,9
4OREMOVETHEBITREVERSETHE
ABOVE PROCEDURE )F BIT DOES
NOTREMOVEEASILYTAPTHECOLLETNUTWITHWRENCHTORELEASE
!VOIDPOSSIBLEDAMAGETOCOLLET.EVERTIGHTENCOLLETWITHOUT
ABIT
./4%4HISTOOLISSHIPPEDCOMPLETELYASSEMBLED.OASSEMBLYTIMEORTOOLSARE
REQUIRED
!33%-",9
"
!
&IG
&IG
