9
To insTall baTTery pack:
Insert battery pack firmly into tool until an
audible click is heard
as shown in
Figure b.
Ensure battery pack is fully seated and
fully latched into position.
To remove baTTery pack:
Depress the battery release button (C1) as
shown in
Figure c and pull battery pack out of tool.
trigger Switch & forward/Reverse Button - figure d
• The drill is turned ON and OFF by pulling and releasing the trigger switch (1) shown in
figure d
. The farther the trigger is depressed, the higher the speed of the drill.
• A forward/reverse control button (2) determines the rotational direction of the tool and
also serves as a lock off button.
• To select forward rotation, release the trigger switch and depress the forward/reverse
control button on the right side of the tool.
• To select reverse, depress the forward/reverse control button on the left side of the tool.
• The center position of the control button locks the tool in the off position. When
changing the position of the control button, be sure the trigger is released.
Adjusting torque control - figure e
This tool is fitted with a torque adjustment collar (3) to select the operating mode and to
set the torque for tightening screws. Large screws and hard workpiece materials require
a higher torque setting than small screws and soft workpiece materials.
• For drilling in wood, metal and plastics, set the collar to the drilling position symbol
• For screwdriving, set the collar to the desired setting. If you do not yet know the
appropriate setting, proceed as follows:
• Set the collar to the lowest torque setting.
• Tighten the first screw.
• If the clutch ratchets before the desired result is achieved, increase the collar setting
and continue tightening the screw. Repeat until you reach the correct setting. Use
this setting for the remaining screws.
dual Range Switch - figure f
The dual range feature of your drill allows you to shift gears for greater versatility.
• To select low speed, high torque setting (position 1), turn tool off and permit to stop.
Slide gear shifter button (4) away from the chuck.
• To select the high speed, low torque setting (position 2), turn tool off and permit to
stop. Slide gear shifter button back toward the chuck.
Note:
Do not change gears when tool is running. If you are having trouble changing
gears, make sure that the dual range gear button is either completely pushed forward
or completely pushed back.
keyless chuck - figure G
WARNING
:
Make certain the battery pack is removed to prevent tool actuation
before installing or removing accessories.
To insert a drill bit or other accessory:
1. Grasp the chuck (5) and rotate it in the counterclockwise direction, as viewed from
the chuck end.
2. Insert the bit or other accessory fully into the chuck, and tighten securely by rotating
the chuck in the clockwise direction as viewed from the chuck end.
WARNING
:
Do not attempt to tighten or loosen drill bits (or any other accessory)
by gripping the front part of the chuck and turning the tool on. Damage to the chuck and
personal injury may occur when changing accessories.
Screw driving
• For driving fasteners, the forward/reverse button should be pushed to the left.
• Use reverse (button pushed to the right) for removing fasteners.
Note: When moving from forward to reverse, or vice versa, always release the
trigger switch first.
drilling
• Use sharp drill bits only.
• Support and secure work properly, as instructed in the Safety Instructions.
• Use appropriate and required safety equipment, as instructed in the Safety Instructions.
• Secure and maintain work area, as instructed in the Safety Instructions.
• Run the drill very slowly, using light pressure, until the hole is started enough to keep