10
Turn On and Turn Off The Appliance
If the appliance is in
Stand-By-Mode,
it is put in
Operating-Mode
by pressing
the
On/Off
button at least 1 second. A buzzer signal indicates the
successful operation acoustically.
On all zones
a ´0` appears and all
Decimal Points
of the zone
flashes (1
sec on, 1 sec off).
If there is no operation within 10 sec, the display of all zones
will turn off.
If the displays are turned off, the zone
will be set into
Stand-By-Mode
.
If is pressed more than 2 sec (in
Operating-Mode
), the appliance is
switched off and is set into the
S-Mode
again. The appliance can be turned
off by pressing at any time; even if other buttons are pressed
simultaneously.
If there is a residual heat of a heater remaining, this will be indicated in the
correspondent heat setting
Zone
Display
.
Select Zone
If
a
single
zone
is
chosen
with
the
corresponding zone
Active/Deactive
Zone Button
, the
Decimal Point
of the related
Heater Display
flashes.
For the
selected
heater
,
you
can
set the heat level between 1-9 by touching the
Heat Setting Slider Buttons
The slider button must be pressed within 3 sec, otherwise the zone selection
is erased and heat setting dot will disappear (
Decimal Point
). If there is no
further operation within 10 sec, the heater falls back into the
S-Mode
.
The heat setting can always be changed by pressing between
level 1-9.
Each sliding operation or each display change is quitted by a buzzer signal.