Portable Power Technology
Unit 2 Meadow House Business Centre www.portablepow ertech.com
Meadow House · London Road · West Kingsdown +44 (0) 1474 761051
Kent · TN15 6ER
Main (Press Display button to switch pages)
Input Voltage
->
<- (E)nergy Saving / (S)tandard Mode
Output Watts* ->
<- (B)luetooth Connection
Output Hz
->
Temperature
->
Output Volt Type
->
Countdown Timer
->
* The output wattage is about ± 5% and for reference only. Please use a dedicated AC power meter if a precise value is needed.
Protections
Pre-Alarm
<!>
: Low Voltage, Overload, Overtemp
Shutdown
(X)
: Low Voltage, Overload, Overtemp, Short Circuit, High Voltage
Example:
Settings
By App
: When the setting is adjusted thru App, the display will temporarily showcase the configuration. Example:
By Display Button
: User can change settings thru display button, please visit the website for detailed display menu
https://linkup-get.app/instruction
6.
Installation
Connect Battery
(CAUTION: DO NOT REVERSE INPUT)
Use the
RED
battery cord to connect from (+) of the positive terminal to (+) of the DC battery. Then, Use the
BLACK
battery cord to connect from
(—)
of the negative terminal to
(—)
of the DC battery.
Connect Chassis Earth
The chassis earth lug should be connected to an earth point, which will vary depending on where the power inverter is
installed. In a vehicle, connect the chassis ground lug to the chassis of the vehicle. In a boat, connect to the boat’s
ground system. In a fixed location, connect to earth.
Connect Remote Switch (Optional)
Connect the remote plug to the remote port in the front panel. Turn the inverter power switch from Off (
○
) to the
Remote Mode (
＝
). When in remote mode, the inverter’s main power will be controlled by the remote switch.
7.
Operation
Power On
When connected to any appliance, be sure to turn on the inverter first. Then, turn on the power switch of the appliance.
Energy-Saving Mode
Under energy-saving mode, the inverter will detect AC output every 4~6 seconds thus causing a 4~6 seconds delay to
start up. When using power tools such as drill, electric saw, mower, …etc., we suggest switching to normal mode for
better response time.
Long Hours Operation
When the inverter operates in full output capacity for a long period, the temperature of the inverter will increase and
potentially shutdown by the over-temperature protection. Therefore, it is recommended to reduce the AC output
capacity if a long continuous operating time is required.
