37
Installation Instructions
DE
EN
FR
IT
ES
PT
NL
SV
FI
DA
NO
EL
CZ
HU
PL
HR
SR
SK
SL
ET
LT
LV
RO
BG
MK
Installation Instructions
Basic Wall Mount
Selecting installation location
The basic wall mount is designed for indoor and
outdoor installations.
The following criteria must be considered when
selecting a suitable installation location:
– Install the electrical socket and basic wall mount
preferably in a covered area protected against
direct sunlight and rain (e.g. in a garage).
– Do not spray the basic wall mount directly with
water (e.g. high-pressure cleaning equipment or
garden hoses).
– Do not install the basic wall mount under
suspended or hanging objects.
– Do not install the basic wall mount in stables,
livestock buildings or locations where ammonia
gases occur.
– Install the basic wall mount on a smooth surface.
– In order to ensure secure fastening, check the
condition of the wall before installing.
– Install the basic wall mount so that it is not near
pathways and the charging cables do not cross
any pathways.
– Install the basic wall mount so that the distance
between the plug and the socket does not exceed
the length of the available supply cable.
– Install the electrical socket as close as possible to
the preferred vehicle parking position. Take the
orientation of the vehicle into account.
– The distance of the electrical socket from the
floor and ceiling should be selected in compliance
with national regulations and standards so that
comfortable use is ensured.
f
Refer to chapter “Safety Instructions” on
page 23.
Tools required
– Spirit level
– Power or hammer drill
– Screwdriver
Installing the basic wall mount
Fig. 8: Drilling dimensions
1.
Mark the drill holes on the wall.
2.
Drill the mounting holes and insert wall plugs.
3.
Press wall mount
2
from the front into the cable
route
1
.
4.
Screw the wall mount onto the wall.
DANGER
Electric shock, fire
Improper use of the charger or non-compliance with
the safety instructions may result in short circuits,
electric shocks, explosions, fire or burns.
e
Do not install the basic wall mount in potentially
explosive atmospheres.
e
To reduce the risk of explosion – particularly in
garages – make sure that the control unit is
located at least 50 cm above the floor during
charging.
e
Observe the locally applicable electrical
installation regulations, fire protection measures,
accident prevention regulations and escape
routes.
9Y0000003B-EU.book Page 37
