Porsche Mobile Charger Connect, Owner'S Manual, Page: 17 / 646

Installing
15
Fig. 8 Drilling dimensions
1. Remove plug holder
1
from the cover (Fig. 8)
2
(Fig. 8).
2. Mark the drill holes on the wall.
3. Drill the mounting holes and insert wall plugs.
4. Screw the plug holder
1
(Fig. 8) to the wall.
5. Fit the cover
2
(Fig. 8) onto the plug holder
1
(Fig. 8) from below and press it upwards.
Inserting the control unit in the wall
mount
Fig. 9 Inserting control unit
1. Guide the vehicle cable through the lower open-
ing in the basic wall mount, fit the bottom of the
control unit on the locking lug and engage it by
pushing it to the rear.
2. Guide the supply cable through the upper open-
ing in the basic wall mount and lock the snap
ring by pushing it to the left.
3. Insert the vehicle plug into the plug holder.
Charging dock installation
There are two options for securing the charging dock.
The installation variant depends on the type of power
cable (exposed or concealed).
–
Installation without spacer (concealed power
cable): The mounting plate is fitted directly to
the wall.
– Installation with spacer (exposed power cable):
The mounting plate is fitted on the wall using a
spacer for the power cable.
Installation without spacer
Fig. 10 Drilling dimensions
1. Mark the drill holes on the wall.
2. Drill the mounting holes and insert wall plugs.
3. Screw the mounting plate to the wall.