302
Minor Repairs
Maintenance Note
The jacking point on the vehicle must be free of
dirt.
1. Slightly loosen the wheel bolts of the wheel to
be changed.
2. Only set up the jack at the rear jacking point
designed for the purpose. The jack foot must
be in contact over its whole area and must be
positioned directly below the head piece.
Use a suitable support if necessary.
3. Hold jack still and wind it up until its head
enters the jacking point on the vehicle.
Only jack vehicle up until the wheel to be
changed is completely off the ground.
4. After lowering the vehicle, remove the jack.
Front jacking point
Access to the jacking points differ according to
the respective vehicle equipment.
Jacking points
f
Set up jack only at the points provided
A
or
C.
Rear jacking point
The rear jacking point is accessible after removing
the covering cap
B
from the sill cover.
Removing covering cap:
f
Pull out covering cap
B
at the bottom at the
rear.
Inserting covering cap:
Insert the covering cap
B
in the bottom guides and
push in completely until you feel the upper lugs
snap into place.
