Porsche 9Y0.971.675.BE, Driver Manual, Page: 62 / 1111

60
Fig. 30 Drilling dimensions
1. Remove the connector fastener
1
(Fig. 30) from
the cover
2
(Fig. 30).
2. Mark the drill holes on the wall.
3. Drill the mounting holes and insert wall plugs.
4. Screw the connector fastener
1
(Fig. 30) onto
the wall.
5. Fit the cover
2
(Fig. 30) onto the connector fas-
tener
1
(Fig. 30) from below and push up.
Attaching the control unit to the wall
mount
Fig. 31 Attaching the control unit
1. Route the vehicle cable through the lower open-
ing of the basic wall mount, place the bottom of
the control unit on the locking tab and push back
to engage.
2. Guide the supply cable through the upper open-
ing in the basic wall mount and lock the circlip by
pushing it to the left.
3. Insert the vehicle plug in the connector fastener.
Installing the charging dock
There are two options for attaching the charging
dock. The installation variant depends on the type
of power cable (exposed or concealed).
–
Installation without spacer (for concealed power
cables): The assembly plate is mounted directly
on the wall.
– Installation with spacer (for exposed power ca-
bles): The assembly plate is mounted on the wall
with a spacer for the power cable.
Installation without spacer
Fig. 32 Drilling dimensions
1. Mark the drill holes on the wall.
2. Drill the mounting holes and insert wall plugs.
3. Screw the assembly plate to the wall.