Porsche 996 TT, Repair Manual

Page: 1107 / 2099

=> Notes on the installation of partly detached door sealing films
3 Installing frame Position the frame −19− on the sound box. Make sure that the door sealing
film cut−out is positioned correctly on the sound box.
Screw in fastening screws −18− and tighten.
4 Installing side airbag Position side airbag −17− on the door and tighten fastening screws −16− .
Tightening torque:−10 Nm (7.5 ftlb.)−
The fastening screws −16− must be replaced each time they are undone.
5 Engaging bowden
cable.
Connecting electrical
plug connection. Engage bowden cable −7− in the door handle. Pull the hook out of the end
piece of the sleeve only after installation in the door handle. Clip plastic
clip into the door handle.
Connect electrical plug connections −8, 9− .
6 Installing door trim
panel The clips −13, 14− must be replaced every time the door trim panel is
removed.
Position the door trim panel on the door and clip it in.
7 Installing the airbag
plastic cover Position fastening screws −5− in the door trim panel and tighten.
=> Tightening torque
Press in plastic cover. Make sure the logo reads correctly.
8 Installing cover Screw in the fastening screws −2, 3, 4− and tighten. Clip in the cover −1−
on the door handle.
top of page
Installation note for door sealing film
Installation note on door sealing film for vehicles without side airbag
The spare door sealing film comes with 4 holes for fastening the side airbag. For vehicles without airbag, the
holes in the door sealing film −2− must be covered with commercially available adhesive tape −1−
Notes on the installation of partly detached door sealing films
Door sealing films which have become completely detached or are torn must always be replaced.
einordnung
Installation note for door sealing film 1044