possible to operate a sensor just from a remote control. Sensors only communicate with static controllers.
Product description
The Popp Z-Weather station was designed for the outdoor use and gathers all relevant data regarding the
weather.
The Z-Weather station continuously measures the velocity and can, for example, close and open the blinds and
awnings according to it. It also measures the rotation which allows a calculation of the wind yield per day and
year. Moreover the Z-Weather station has sensors to measure the humidity, temperature, barometric pressure
and dew point. This way all critical data is covered and saved.
Batteries
The unit is operated by batteries. Use only batteries of correct type. Never mix old and new batteries in the
same device. Used batteries contain hazardous substances and should not be disposed of with household
waste!
Battery Type: 1 * SuperCap/Solar
Installation Guidelines
The device can be installed on nearly every surface. It is recommended to install it with the wind pedals on
top and with the solar panel facing in a direction where it can collect enough sunlight. For full functionality
the Z-Weather station is to be placed in a location where it can reliably measure the velocity. The device
should always be in range to the main controller to make sure the data is sent correctly.
Behavior within the Z-Wave network
I
On factory default the device does not belong to any Z-Wave network. The device needs to join an
existing wireless network to communicate with the devices of this network. This process is called Inclusion.
Devices can also leave a network. This process is called Exclusion. Both processes are initiated by the primary
controller of the Z-Wave network. This controller will be turned into exclusion respective inclusion mode.
Please refer to your primary controllers manual on how to turn your controller into inclusion or exclusion
mode. Only if the primary controller is in inclusion or exclusion mode, this device can join or leave the
network. Leaving the network - i.e. being excluded - sets the device back to factory default.
If the device already belongs to a network, follow the exclusion process before including it in your network.
Otherwise inclusion of this device will fail. If the controller being included was a primary controller, it has to
