Page 6
Emhart Teknologies - 50 Shelton Technology Center, Shelton CT 06484 - Tel. (203) 924-9341 - Fax (800) 225-5614
Common Nosepieces
* Included with the tool
Use FAN239-176 instead of DPN239-144 (installed) when using 3/32” (2.4mm) or smaller diameter
rivets.
Basic Tool Operation
Before operating the tool check the following:
Inspect tool for damage or leaking oil –
do not use tool if it is damaged or leaking oil.
Check that correct nosepiece is fitted and tightened to 60 - 65 in-lbs [6.8 – 7.3 N-m] torque.
Check that the nose housing nut (8) is tight – hand tighten only.
Connect tool to air supply – see air supply requirements (page 4).
Fit Mandrel Collector (96) – (MCS tool only).
Open air supply valve by Sliding red OS Sleeve (93) on side of tool (see note below).
Insert rivet into nosepiece.
Position rivet in work piece.
Pull trigger to set rivet.
Release trigger – if equipped, MCS suction will draw mandrel into the collector.
!
Note: The ProSet
®
1600 has an OS (Open-Shut) Valve for switching the air supply ON and OFF to
save air when the tool is not in use.
Closed End
HR Rivets
Rivet Diameter
Open End
Steel Mandrel
Aluminum
Mandrel
Aluminum
Body
Steel
Body
Jaw Pusher
2.0
mm PRN214
- - - -
FAN239-176*
(PRG402-02 - JAWS)
3/32” (2.4 mm)
PRN314*
-
-
-
-
FAN239-176*
1/8” (3.2 mm) or
7/64” (2.8 mm)
PRN414* PRN424 PRN434 PRN414* PRN4K
5/32” (4.0 mm)
PRN514*
PRN524
PRN534
PRN514*
-
DPN239-144*
Air Supply ON
: Open OS Valve
by sliding OS Sleeve in the
direction shown (up).
Air Supply OFF
: Close OS Valve
by sliding OS Sleeve in the
direction shown (down).
OS Sleeve