1
101216
Con
ten
ts
All-Pro Water Basketball Game
Product Care & Storage
NOTE: The parts of the frame are made of PVC pipe and PVC glue may be used to secure all connections.
Your new poolside game has been made with many non-corrosive quality materials and should provide you with
many years of enjoyment with proper care. However, sun and chemically treated pool water (chlorine) are natural
enemies of many synthetic materials. For maximum life of your game:
Do not leave the game floating in the pool when not in use.
After use, wash away the chlorine pool water with tap water from a
garden hose.
When not in use, store your game in a dry place away from direct
sunlight and chemicals.
Net (1)
Basketball (1)
Inflating Needle (1)
Small Top Hoop (1)
U-Shaped Half Circles (2)
(Large Bottom Hoop)
Need Assistance?
Call our Customer Service Line:
Visit our website @ poolmaster.com
eMail us @ [email protected]
800.854.1492
Rec
ommended
T
ools
3" Foam Floats (5)
Uprights (2)
Set Screws (5)
Male Coupler
and Set Screw
Rubber
Mallet
PVC Glue
Phillips
Screwdriver
A
ssembly I
nstr
uc
tions
1
2
3
4
5
6
*Net not shown for
Illustration purposes
To assemble the Large Bottom Hoop, insert end of Male
Coupler into other U-Shaped Half Circle (PVC Glue optional) as
shown and secure with Set Screw.
Twist (5) 3’’ Foam Floats onto the Large Bottom Hoop.
Thread net on PVC Hoop
1.This is the net right out of the package. You will be working
with the longer looped end.
2.This is a close-up of the circled portion on diagram 1. This is
one loop.
3.Fold the loop toward you, creating two loops.
4.Insert your finger through the two loops.
5.Release the thumb holding the loop in place and pull on the
two middle strings. The loop should slide up and catch your
fingers.
6.Take the loop from your finger and slide onto the basketball
hoop. Continue this process with each loop until all loops are
on the hoop.
Insert the pipe from the Large Bottom Hoop into the bottom of
both Bell End Uprights and secure with (2) Set Screws.
Insert the pipe from the Small Top Hoop into the top of both
Bell End Uprights and secure with (2) Set Screws.
Use Ball Needle and a hand pump (not included) to inflate the
ball to approximately 9’’ in Diameter.
2.
1.
3.
4.
5.
6.
1
3
5
4
