7
• Turn the Solar Heater unit over and locate the
two openings – one will be used for an INCOMING
hose from the filter and the other for an OUTGOING
hose back into the pool. It does not matter which
opening you use for which purpose, but note that
whichever opening you use for the hose coming
INTO the Solar Heater, you
MUST USE THE
WATER CONTROLLER COMPONENT (F)
noted in Diagram 3.
Make sure you know which opening is INCOMING
and which is OUTGOING.
• Once you’ve assembled the Diagram 3 components onto the end of the hose, insert the
prepared end into the opening on the underside of the Solar Heater that you designated as the
INCOMING opening.
NOTE: There are notches on the side hose connectors that need to match to the notch holes on the
Solar Heater openings. Once they are matched up,
MAKE SURE yOU TURN TO LOCK IN PLACE
.
• With a new hose, prepare one end as your OUTGOING hose connection by following Diagram 4
for order of parts and connection to each other. This connection will direct the warmed water out
of your Solar Heater and into your pool.
DIAGRAM 4
OUTGOING HOSE CONNECTION COMPONENTS
Hose end (A) + clamp (D) + hose reducer (E) + side hose connector (B) + O-ring (C)
(Use your flat head screwdriver to loosen and tighten the hose clamps)
C
B
E
D
A
Incoming & Outgoing
Openings
