7
TOOLS NEEDED
Hacksaw
Tape Measure
In-Line Installation - 5400 Model
For pools 7,000 to 40,000 gallons
Allow a minimum
of 12” above and
on each side of
POOL FROG Cycler
to ensure room for
easy replacement
of POOL FROG
Mineral Reservoir
and POOL FROG
Bac Pac.
Do NOT install
this POOL FROG
Cycler off-line.
Bi-flow valve design allows installation
in either flow direction.
Measure the distance between
the outside adapters and cut out
a section of pipe 3” less than
that dimension.
Following Primer directions, brush Primer on the inside of the
adapters and to ends of pipe. Repeat this process with PVC
cement following manufacturer’s directions on that product.
Insert PVC pipe into adapters
with a twisting action. Hold in
place 5 to 10 seconds to bond.
To prevent damage to heaters or filters, see your dealer about
installing a
corrosion resistant check valve
which will reduce
the back flow of chlorine gas when the Cycler is turned off.
For better stability,
POOL FROG Cycler
may be mounted on
a treated wood base
using
Phillips pan head
screws,
one in front
and one in back. If you
have questions about
stability, please contact
your dealer or King
Technology.
MATERIALS NEEDED
Primer and PVC Cement
SECURE CYCLER
2.
3.
4.
12"
12"
12"
OR
Primer
PVC
Cement
PVC
Cement
Primer
[
\
1.
Water
CYCLER
MeteredPoo
l Purifier
Do NOT install in copper pipe if
using POOL FROG Bac Pac as
chemical corrosion could lead to
pipe failure.
The POOL FROG Cycler should always be installed
between the filter and pool (or between heater and
pool if applicable).
Never install POOL FROG Cycler
before the heater or damage to the heater could
occur.
Install
